| SCI Pro-One Tutorial
How to install new bushings on a Pro-One We recently installed new bushings on a Pro-One and thought we would share our experience with everyone here in pictures. The process took roughly 1-2 hours, but was well worth it! This Pro-One is a J-Wire keyboard. This technique also works with the membrane keyboard Pro-Ones.
SCI Pro-One
First Take the wood Sides off
As you lift the top up, be careful to not damage the ribbon cable. Remove ribbon as necessary.
Top removed
Top off, another view
Keys, before bushings removed
Another view of keys pre-bushing removal
Notice the four screws that need to be removed to remove the keybed
Keybed removed
Cutting off an old bushing
Another view of cutting a dead bushing
Look at the way the old bushing crumbles
Removing another dead bushing
...and another.
Shake out bushing pieces after cutting all off
Mmmm, bushing fragments...
New bushing sliding into place
A screwdriver can help apply the new bushing.
New bushing now on and in place
Close-up of new bushing in place
Continue applying bushings until all keys complete!
|
